DISCONTINUED ECM C219900560 1/4″ Bleeder/Vacuum Valve
Please visit one of the links below for more comparable products.
ECM C219900560 1/4″ Bleeder/Vacuum Valve
This 1/4″ bleeder valve (C219900560) is for most ECM espresso machine models.
Reference Part Numbers. This part may be a suitable replacement for the following part numbers:
Bezzera 7452502
BFC 3630001
Brasilia 05062.4.00.09
Brugnetti-Aurora 000634
Conti : 408898
Elektra 00200034
Expobar 65000205
Faema 2161118968
Fiorenzato CS A1300007
Grimac A1300007, CA253, F814, and GR733
Lavazza : 10084131
Marcfi-Ancas BL-2054
Nuova Simonelli 01000023
Pavoni 453203
Rancilio 10060055 and 10-060-055
Royal 3630001
San Marco 202199 and CPCVAL0040
Sanremo 10652040 and 10652040A
Spaziale 00508
Synesso 1.4262
Vibiemme VALUSFME and VALVSFME
Victoria Arduino 01000023
Wega FM0814
ECM C219900560 1/4″ Bleeder/Vacuum Valve
| Brand | ECM Manufacture |
|---|
Ask a question
Please ask follow up questions as a new question. Submitted questions will be first reviewed, answered, and lastly publicized.
-
Is this the right vacuum valve for the ECM Synchronika? It doesn't look like the one I just pulled out of my boiler . . . no place for the silicon tubing to attach?
-
Q Is this the right vacuum valve for the ECM Synchronika? It doesn't look like the one I just pulle...... Read more answer nowAsked by bzb on December 24, 2019 6:20 amAnswered by the admin It is best to match the one on your machine.
Question about this part.....I have an ECM Germany, purchased from 1st Line in July 2014 (great machine). I hear a hissing sound which I believe is coming from the Bleeder/Vacuum Valve and read it should be replaced rather than to try and clean it. 1) Do you think this is the correct diagnosis? Is this the correct part for Model #ECMG88074 (Serial #201405310)? I would also order the 1/4 Copper Gasket. Any advice for replacing this part myself? Many Thanks. Long term customer in Montclair, NJ.
-
Q Question about this part.....I have an ECM Germany, purchased from 1st Line in July 2014 (great m...... Read more answer nowAsked by BruceG07042 on May 14, 2018 5:24 pmAnswered by the admin
Thank you for believing in 1st-line.
Usually, this is the first place limescale hits on this machine. Its usually best to replace as sometimes the limescale damages the metal. As for the copper gasket, the old one can be re-used in most cases. In the very few cases that limescale has severely built up and eaten away at the gasket, then it should be replaced.
