Heating Element Replace – Vibiemme Domobar Super HX

Disclaimer: The technical support below for information purposes only. 1st-line Equipment, LLC is not responsible for any injury or damages resulting from such information. Please note that parts are available for purchase from 1st-line Equipment. These parts do not include any technical support. If you’re not familiar with the technical aspects of repairing equipment, please order a diagnosis on our website.

By continuing to read further, you agree to abide by all the terms and conditions on this web site. If you do not agree, please stop here.


  1. Unplug the machine.
  2. Remove the outer shell. It is held on by 3 screws.
  3. Turn the machine on it’s side so that the element is facing UPWARD. This will ensure that when the element is remove, no water will leak out onto internal parts.
  4. Unplug the wires on the heating element.
  5. Use an open ended wrench or large socket to remove the element.
  6. Change over gasket to new element.
  7. Put on new one hand tight then wrench tight 1/4 turn OR wrench tight then 1/8 solid turn to seal.
  8. Stand up, plug in wires, plug in and test – check for any water leaks before putting body back on.
heating-element-replace-1

Please note the above information is subject to copyright. It cannot be published by any means without the expressed written consent of 1st-line Equipment, LLC.

Ryan S. from United States (US) purchased

Bottom Gasket for E61 Grouphead Mushrooms

9 hours, 49 minutes ago