Lever Handle Alignment – Strega

Disclaimer: The technical statements, support, information and recommendations contained herein are believed to be accurate as of the date hereof, but 1st-line Equipment, LLC does not make representations or warranties, express or implied, as to its accuracy, its completeness, or the results to be obtained. The information is being provided for informational purposes only and is intended for use by persons having adequate skill and expertise regarding the proper selection, use and application of the products and recommendations and at their own risk and discretion.

1st-line Equipment, LLC is not responsible for any injury or damages from such information. Please note that parts are available for purchase from 1st-line Equipment, LLC self service parts portal. These parts do not include any technical support. If you're unfamiliar with the technical aspects of repairing equipment, please contact a professional for proper evaluation.

By continuing to read further, you agree to abide by all the terms and conditions on this website. If you disagree, please leave our website.

Upon installation of the lever handle on the grouphead, do not tighten all the way as the handle will not be aligned. Once fully tightened, the lever handle should be unscrewed out until it is in a desirable position. Tighten the allen key screw in the grouphead to hold the lever handle in place.

The Allen key is included in the purchase of a Strega located in the accessory box.

Close-up of a metallic mechanical part with a circular hole in the center; a red arrow points to threads visible inside the hole, illustrating precise Lever Handle Alignment for Strega machines. © 2025 1st-line.com

Please note the above information is subject to copyright. It cannot be published by any means without the expressed written consent of 1st-line Equipment, LLC.