DISCONTINUED Rancilio 33-111-010 Heating Element 800 watts 110 volt for Rancilio Betsy, Silvia V1 ONLY
Please visit one of the links below for more comparable products.
We recommend purchasing the boiler o-ring (Qty. 1) and the heating element o-rings (Qty. 2) which are not included with the purchase of this item.
110 volts 800 watts
Please check your machine inside before ordering as this only fits Silvia V1 machines. This may fit the Rancilio Audrey or Rancilio Rialto. You need to remove the top cover and make sure there are 2 removable nuts on the heating element posts. Version 2 and 3 boilers have welded in heating element posts and this part can not be used to replace it.
If you have higher than version 1, you will need the following part 10-705-636..
[ls_content_block id=”24683″]| Brand | Rancilio |
|---|
Ask a question
Please ask follow up questions as a new question. Submitted questions will be first reviewed, answered, and lastly publicized.
-
I'm looking to do some surgery on my Silvia's boiler. It's a v2 with a welded element. I see you have a 2-post 110v Heating Element in stock with the threaded supports. Does this come with the nuts too?
-
Q I'm looking to do some surgery on my Silvia's boiler. It's a v2 with a welded element. I see you ...... Read more answer nowAsked by Vince on February 16, 2022 12:38 pmAnswered by the admin
It does not always come with the nuts. However, this heating element is NOT intended for the boilers with welded hating elements.
Can you send the link for the 2 o-rings I would need for the nuts on the top of the heating element? Not sure which ones I need. Thanks.
-
Q Can you send the link for the 2 o-rings I would need for the nuts on the top of the heating eleme...... Read more answer nowAsked by Ken Richardson on September 21, 2020 4:35 pmAnswered by the admin We updated the page with the element o-rings, but the boiler o-ring is no longer available. Sorry, many parts have been discontinued by the manufacturer.
Will this fit the v2? I noticed you dont have a v2 element listed on your site.
-
Q Will this fit the v2? I noticed you dont have a v2 element listed on your site. answer nowAsked by James V on December 14, 2018 10:01 pmAnswered by the admin
If you have a nut and threading on your original element, then yes.
can this unit be retrofitted into a Rancilio Silvia v.3 boiler? I realize that the brazed element must be drilled out.
-
Q can this unit be retrofitted into a Rancilio Silvia v.3 boiler? I realize that the brazed element...... Read more answer nowAsked by steve on November 23, 2017 12:01 amAnswered by the admin Sorry, it can not as the heating element most likely will not fit the redesigned V3 boiler. In addition, there is a safety issue when the boiler reaches steam operating temperature.
