DISCONTINUED – Mahlkonig DK 27 LVS Industrial Coffee Grinder
This product has been discontinued at 1st-line. Please visit one of the categories below for more comparable products.
Mahlkonig DK 27 LVS Industrial Coffee Grinder
The “Big Enduring One” of the Mahlkonig Industrial Coffee Grinders.
Similar to the DK 15 but with greater capacity. The mobile container with a capacity of approximately 53 gallons (200 liters) simplifies transport of the ground product. Grinding discs made from wear resistant steel provide fine and cool grinding.
Features:
- Small space requirement.
- Movable container for the ground product.
- Tight discharge chute for dust reduced grinding.
- Large hopper.
- Lock plate to interrupt the feeding of the product to be ground.
- Integrated hopper magnets as protection against metal in the product.
- Powerful 3-phase motor with surface cooling and high starting torque.
- Air cooling of the grinder casing.
- Service-free, constantly greased bearings.
- Motor protection against electrical overload.
- Extremely wear resistant, precision grinding discs for a homogenous ground product.
- The grind adjustment wheels provides fine, accurately repeatable control of the degree of finess.
Specifications:
- Measurements: 63″ H x 31.3″ W x 48.4″ D (160.02 cm H x 79.5 cm W x 122.94 cm D).
- Weight: 341.7 pounds (154.99 kilograms).
- Shipping weight: 529.1 pounds (240 kilograms).
- Power: 208-240 volts, 60 hertz, 3 phase.
- Motor power: 7.5 hp, 25 amps.
- Motor speed: 1160 rpm.
- Hopper capacity: 66 pounds (29.94 kilograms).
- Grinding capacity: 616 pounds (279.41 kilograms) / hour for Turkish, 660 pounds (299.37 kilograms) / hour for medium.
- Grinding disc material: Tool steel.
- Grinding disc diameter: 180 mm.
- Container measurements: 27.6″ H x 27.2″ W x 31.1″ D (70.1 cm H x 69.09 cm W x 78.99 cm D).
- Container capacity: 53 gallons (200 liters).
Notes:
- Please note that that you will find coffee grinds in these grinders when delivered as they are all tested by the manufacturer. They try to clean them as best as possible, but they can not remove all grinds and those remaining grinds do become loose and spread during shipping.
- Please note that the manufacturer will produce different colors of this grinder. They do not notify any retailers in advance to which color will be imported. Therefore, the color of the grinder shown is for illustrative purposes, and the grinder ordered and shipped will most likely be different than shown. This applies to all resellers in the USA for this manufacturer.
- Please note that the electrical cord is placed between the packaging (foam or cardboard) and the underside body of the grinder. During shipping, it is normal for a bend or insignificant blemish/slice to damage the cord.
For more Mahlkonig equipment, please visit our Mahlkonig brands page. If you have any questions, please reference the Q&A tab on each product page.
| Brand | Mahlkonig |
|---|
Espresso Grinder Warning
- CLEANING WARNING: We recommend using grinder cleaning agents. We do not recommend any removal of the burrs or burr carrier for cleaning as re-assembly can cause damage.
- ELECTRICAL WARNING: To avoid electrical damage to this espresso grinder which is not considered a manufacturer's defect, please acquire and install a single-outlet surge suppressor rated at 1080 joules or higher. The lack of the recommended surge suppressor, the espresso grinder can be damaged at the power switch, the capacitor, the motor, or the wiring.
- Changing grind settings: As with all coffee grinders, it is very important to only change grind settings when the unit is powered ‘on’ and the burrs are in motion. If you do not do this, the burrs will ‘gunk’ up and require cleaning by you every time this occurs. Changing the grind settings when the burrs are not in motion will render the grinder to only produce very coarse grinds or no grinds at all. If this result occurs, this will be considered operator error for lack of following directions, and not be classified as a defective grinder.
- Finding coffee grinds in a new grinder: We have confirmed that the manufacturer tests EVERY grinder with coffee beans before it leaves their facility, but they are not always able to get every trace of coffee out of the grinders after testing. As a result, you may find coffee beans or grinds inside your grinder, or there may be grinds in the packaging when you unwrap it.
- Static issues: There are static issues with all grinders, even the highest quality models. We firmly believe that the static comes from the coffee beans. If you are having static problems with your coffee grinder, trying using a different blend of beans.
- Replacing burrs: NEVER use a flat head screwdriver and hammer to wedge under the burrs for removal. This could badly damage your grinder.
- Electrical cord: Please note that the electrical cord is placed between the packaging (foam or cardboard) and the underside body of the grinder. During shipping, it is normal for a bend or insignificant blemish / slice to damage the cord.
Be the first to review “DISCONTINUED – Mahlkonig DK 27 LVS Industrial Coffee Grinder” Cancel reply
This site uses Akismet to reduce spam. Learn how your comment data is processed.
Ask a question
Please ask follow up questions as a new question. Submitted questions will be first reviewed, answered, and lastly publicized.
There are no questions yet. Be the first to ask a question about this product.
Reviews
There are no reviews yet.