Below is an informational chart of the different statuses you will see on the PID controls.
You can also find this information on page 33 in the instruction manual.
ON/OFF Pilot Light | Temperature Pilot Light | Steam Pilot Light | Screen | |
Coffee mode | ||||
Start-up | ON | Flashing 1Hz | OFF | Real Reading |
Heating | ON | Flashing 1Hz | OFF | Pre-set coffee temp |
Ready to work | ON | ON | OFF | Pre-set coffee temp |
Steam mode | ||||
Steam mode (heating) | ON | ON | Flashing 1Hz | Pre-set steam temp (Flashing) |
Steam mode (start-up warming) | ON | ON | Flashing 2Hz | Pre-set steam temp |
Steam mode (in service) | ON | ON | ON | Pre-set steam temp |
On ending steam mode (cooling) | ON | Flashing 1Hz | ON | Pre-set coffee temp (Flashing) |
Others | ||||
Stand-by mode | ON | OFF | OFF | – |
Dose control fault | ON | OFF | Flashing 2Hz | E01 |
Coffee temp Probe fault | ON | Flashing 2Hz | Flashing 2Hz | E02 |
Coffee exchanger fault | ON | Flashing 4Hz | Flashing 2Hz | E03 |
Steam temp Probe fault | ON | Flashing 2Hz | Flashing 2Hz | E04 |
Steam exchanger fault | ON | Flashing 2Hz | Flashing 4Hz | E05 |
Internal fault | ON | OFF | OFF | E98 |
Please note the above information is subject to copyright. It cannot be published by any means without the expressed written consent of 1st-line Equipment, LLC.