CLEANING RANCILIO ROCKY BURRS
1. Unplug Unit.
2. Remove Bean Hopper Cover.
3. Remove three Screws located in Safety Guard inside Bean Hopper.
4. Lift up Bean Hopper away from Grinder.
5. Spin out Brass Plate where the three Screws were attached.
6. Vacuum coffee grinds from threads on Brass Plate and from Grinding
Chamber.
7. Clean Burrs on Brass Plate and in Grinding Chamber with sharp
knife (be careful not to cut yourself).
8. With cotton swabs dipped in olive oil (or vegetable oil), remove
ALL the coffee grinds from the threads on the Brass Plate and on
the threads in the Grinding Chamber. It is critical to remove ALL
coffee grinds. If you leave coffee in the Chamber, you will not
be able to screw down the Brass Plate enough to get a finer grind.
9. Once all the grinds are removed, screw down the Brass Plate
until you see the Burr inside the Grinding Chamber move. Typically,
the top Brass Plate will not move any further.
10. From the front of the Grinder, look for the forward most Screw
Slot in the Brass Plate and rotate the Brass Plate counter clockwise
until that Screw Slot is to the right of the Grind Selector Button.
11. Place on the Bean Hopper so the Screws align with the screw
holes so that the lowest number setting is to the front.
12. Tighten three Screws. Make sure not to over tighten as this
will crack the Hopper.
Copyright 2003. 1st-line Equipment, LLC. All Rights Reserved. |
